What Do the Thread Patterns on the Surface of the Wire Drawing Machine Look Like

When the wire drawing machine draws wires, two methods can be selected: roller brush oscillation and roller brush non-oscillation. Cooperating with different processing speeds, thread patterns of different lengths can be produced. The abrasive belt rotates at a high speed, and the plate is passed through the abrasive belt by the conveyor belt for grinding and wire drawing. Generally, stainless steel plates, aluminum alloy plates, etc. are made into wire-drawn semi-finished products for further manufacturing into products using plates as raw materials, such as stainless steel elevator wire-drawn door panels, stainless steel cabinets, aluminum alloy chassis, etc.

The key to the operation of the flat wire drawing machine is to find a way to obtain a relatively high polishing rate so as to quickly remove the harmful layer generated during polishing. The former requires the use of a coarser abrasive to have a relatively large polishing rate to remove the harmful layer of polishing, but the polishing harmful layer is also relatively deep; the latter requires the use of fine materials to make the polishing harmful layer shallower, but the polishing rate is low.

After the surface of the aluminum plate wire drawing machine is spray-coated, defects such as coarseness, sandpaper marks, flow marks, whitening, and orange peel on the surface of the paint film may appear. To compensate for these defects, the aluminum plate wire drawing machine is composed of basic components such as a base, a throw plate, polishing fabrics, a polishing cover, and a cover. The motor is fixed on the base, and the taper sleeve for fixing the polishing disc is connected to the motor shaft through screws.