Annealing Furnace Manufacturer: Manufacturing Method of the Wire Take-up Device for Multi-head Annealing Furnaces

In view of the current technical situation, the technical problem to be solved by this utility model is to provide a wire take-up device for a multi-head annealing furnace that adopts an inclined tube structure, has a small volume, is easy to move, has a rolling prevention function, avoids the reversal of the wire winding shaft and the loosening of the wire coil, is simple to operate, and is convenient for production.

The technical solution adopted by this utility model to solve the above technical problems is: a wire take-up device for a multi-head annealing furnace, including a frame assembly, a side plate, a back plate, a front plate, a switch, a cylinder, a bottom plate, a wire take-up assembly, and a locking assembly. The frame assembly includes a horizontal tube, a vertical tube, and an inclined tube. It is characterized in that two symmetrically arranged inclined tubes are fixed on the outer side of the bottom surface of the cylinder, and a horizontally arranged horizontal tube that is symmetrical to each other is fixed at the lower end of each of the two inclined tubes.

A wire take-up assembly is installed on the outer bottom surface of the cylinder. The wire take-up assembly includes a gearbox, a motor, a plug pin, a turntable, a pad strip, and a tail block; the gearbox is fixed on the outer bottom surface of the cylinder, and the output shaft of the gearbox passes through the center of the bottom surface of the cylinder and extends into the cylinder. A motor is installed on the surface of the gearbox, the rotating shaft of the motor is connected to the input shaft of the gearbox, and the motor is connected to the switch.

The plug pin is transversely inserted into the tail block on the output shaft of the gearbox, and the tail block is fixed on the output shaft of the gearbox; both side end faces of the tail block are square, a slot is opened in the center of one side end face of the tail block, a through hole is opened on the other side end face of the tail block, the output shaft of the gearbox is inserted and fixed in the through hole, and the plug pin is embedded in the slot.